1 1 2 Sink Drain - Sink Remodels

1 1/2 Sink Drain

A 1 1/2 sink drain is a common size for sinks in kitchens and bathrooms. It is typically used for sinks with a single basin, but can also be used for sinks with two basins. The drain is typically made of metal, such as stainless steel or brass, and has a diameter of 1 1/2 inches. It is important to choose the right size drain for your sink, as a drain that is too small will not allow water to drain properly, and a drain that is too large will be difficult to install and may leak.

There are two main types of 1 1/2 sink drains: slip-joint drains and compression drains. Slip-joint drains are the most common type, and they are easy to install. They have a rubber gasket that fits over the drainpipe, and the drain is then tightened in place with a nut. Compression drains are less common, and they are more difficult to install. They have a metal washer that fits over the drainpipe, and the drain is then tightened in place with a nut. Compression drains are more likely to leak than slip-joint drains, but they are also more durable.

When choosing a 1 1/2 sink drain, it is important to consider the following factors:

The size of your sink
The type of sink you have (single basin or double basin)
The material of the drain
The type of drain (slip-joint or compression)

Once you have considered these factors, you can choose the right 1 1/2 sink drain for your needs.

How to Install a 1 1/2 Sink Drain

Installing a 1 1/2 sink drain is a relatively easy task that can be completed in a few minutes. The following steps will show you how to install a 1 1/2 sink drain:

Gather your materials. You will need a 1 1/2 sink drain, a wrench, and a putty knife.
Turn off the water supply to your sink. This is usually done by turning off the valves under the sink.
Remove the old drain. To do this, use a wrench to loosen the nut that holds the drain in place. Once the nut is loose, you can pull the drain out of the sink.
Clean the drainpipe. Use a putty knife to remove any old sealant or debris from the drainpipe.
Apply a bead of sealant to the drainpipe. Use your finger to spread the sealant around the drainpipe.
Insert the new drain into the drainpipe. Push the drain in until it is seated against the sealant.
Tighten the nut that holds the drain in place. Use a wrench to tighten the nut until it is snug.
Turn on the water supply to your sink and check for leaks. If there are any leaks, tighten the nut further.

Your 1 1/2 sink drain is now installed and ready to use.