How To Replace Kitchen Sink Faucet

A leaky or outdated kitchen sink faucet can not only be frustrating, but also waste water. Replacing a kitchen sink faucet is a relatively simple plumbing repair that can be completed in a few hours, even if you're a beginner. Here's a step-by-step guide to help you get the job done:

Before you begin, gather the following tools and materials:

New kitchen sink faucet
Adjustable wrench
Plumber's putty
Basin wrench
Flashlight
Bucket

Step 1: Turn off water supply and drain pipes

Locate the water supply valves under the sink and turn them off. Open the faucet to release any remaining water in the lines. If there is a dishwasher connected to the sink, be sure to turn off the water supply to the dishwasher as well.

Step 2: Disconnect old faucet

Use an adjustable wrench to loosen the nuts that hold the old faucet in place. Be careful not to overtighten the nuts, as this can damage the faucet or the sink.

Step 3: Apply plumber's putty

Roll out a small amount of plumber's putty into a rope and place it around the base of the new faucet. This will help to seal the faucet and prevent leaks.

Step 4: Install new faucet

Insert the new faucet into the hole in the sink and tighten the nuts until they are snug. Be sure to use an adjustable wrench to get a good grip on the nuts.

Step 5: Reconnect water supply lines

Reattach the water supply lines to the new faucet. Be sure to tighten the nuts securely, but do not overtighten them.

Step 6: Turn on water supply and check for leaks

Turn on the water supply valves and check for leaks. If there are any leaks, tighten the nuts on the water supply lines until the leaks stop.

Step 7: Enjoy your new faucet!

Your new kitchen sink faucet is now installed and ready to use. Enjoy the convenience of a new faucet and the satisfaction of completing a successful plumbing repair.