Replacement Kitchen Sink Faucet Head

The kitchen sink faucet is one of the most used fixtures in the home. Over time, it can start to show its age, with the finish wearing off or the faucet becoming loose. If your kitchen sink faucet is starting to look worse for the wear, you can easily replace the faucet head yourself. Here's a step-by-step guide to help you get the job done.

Tools and Materials You'll Need

Replacement kitchen sink faucet head
Adjustable wrench
Phillips head screwdriver
Flat head screwdriver
Plumber's putty
Rags

Step 1: Turn Off the Water Supply

Before you start working on the faucet, you need to turn off the water supply. There should be two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise until they are fully closed.

Step 2: Disconnect the Water Lines

Once the water supply is turned off, you need to disconnect the water lines from the faucet. Use an adjustable wrench to loosen the nuts that hold the water lines in place. Be careful not to overtighten the nuts, as this could damage the water lines.

Step 3: Remove the Old Faucet Head

Once the water lines are disconnected, you can remove the old faucet head. Use a Phillips head screwdriver to remove the screws that hold the faucet head in place. Once the screws are removed, you should be able to pull the faucet head straight up and off of the faucet body.

Step 4: Apply Plumber's Putty

Before you install the new faucet head, you need to apply plumber's putty to the base of the faucet. Plumber's putty is a type of sealant that will help to create a watertight seal between the faucet head and the sink. To apply plumber's putty, simply roll it into a rope and then place it around the base of the faucet head.

Step 5: Install the New Faucet Head

Once the plumber's putty is in place, you can install the new faucet head. Align the new faucet head with the faucet body and then push it down into place. Once the faucet head is in place, use a Phillips head screwdriver to tighten the screws that hold it in place.

Step 6: Reconnect the Water Lines

Once the new faucet head is installed, you need to reconnect the water lines. To do this, simply screw the nuts onto the water lines by hand. Once the nuts are tight, use an adjustable wrench to tighten them further. Be careful not to overtighten the nuts, as this could damage the water lines.

Step 7: Turn On the Water Supply

Once the water lines are reconnected, you can turn on the water supply. Turn on both shut-off valves under the sink, counterclockwise. Once the water is turned on, check for any leaks. If you see any leaks, tighten the nuts on the water lines further.

Step 8: Check for Leaks

Once the water supply is turned on, check for any leaks. If you see any leaks, tighten the nuts on the water lines further. You should also check the base of the faucet head for any leaks. If you see any leaks, apply more plumber's putty to the base of the faucet head.