How To Take Out Sink Faucet

Replacing a sink faucet is a relatively simple plumbing repair that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber.

Step 1: Gather your tools and materials

Before you begin, you will need to gather the following tools and materials:

Adjustable wrench
Phillips screwdriver
Flathead screwdriver
New faucet
Plumber's putty
Teflon tape

Step 2: Turn off the water supply

The first step is to turn off the water supply to the sink. There are typically two shut-off valves located under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to close them.

Step 3: Disconnect the water supply lines

Once the water supply is turned off, you can disconnect the water supply lines from the faucet. Use the adjustable wrench to loosen the nuts that connect the lines to the faucet. Be careful not to overtighten the nuts, as this could damage the lines.

Step 4: Remove the old faucet

With the water supply lines disconnected, you can now remove the old faucet. Use the Phillips screwdriver to remove the screws that hold the faucet in place. Be careful not to drop the screws down the drain.

Once the screws are removed, you can lift the faucet up and out of the sink.

Step 5: Clean the sink

Before you install the new faucet, it is important to clean the sink. Use a damp cloth to wipe away any dirt or debris.

Step 6: Apply plumber's putty

Once the sink is clean, you can apply plumber's putty to the base of the new faucet. Plumber's putty is a pliable material that helps to seal the faucet and prevent leaks.

To apply plumber's putty, simply roll a small piece into a ball and place it around the base of the faucet. Press down on the putty to flatten it and create a seal.

Step 7: Install the new faucet

With the plumber's putty in place, you can now install the new faucet. Place the faucet over the hole in the sink and press down to secure it. Be sure to align the faucet with the holes for the water supply lines.

Once the faucet is in place, use the Phillips screwdriver to tighten the screws that hold it in place.

Step 8: Connect the water supply lines

With the faucet installed, you can now connect the water supply lines. Use the adjustable wrench to tighten the nuts that connect the lines to the faucet. Be careful not to overtighten the nuts, as this could damage the lines.

Step 9: Turn on the water supply

Once the water supply lines are connected, you can turn on the water supply. Slowly open the shut-off valves under the sink and check for leaks. If you see any leaks, tighten the nuts on the water supply lines until the leaks stop.

Step 10: Test the faucet

Once the water supply is turned on, you can test the faucet. Turn on the hot and cold water and check for leaks. If you see any leaks, tighten the screws that hold the faucet in place until the leaks stop.

Your new faucet is now installed and ready to use.