Connecting Sink Drain To Trap

Connecting Sink Drain to Trap

The sink drain and trap are two essential components of a plumbing system. The drain allows water to flow from the sink into the trap, while the trap prevents sewer gases from escaping into the home. Connecting the sink drain to the trap is a relatively simple process that can be completed in a few minutes.

### Materials Needed *

Sink drain

Trap

Washer

Slip nut

Pliers

### Instructions 1.

Place the washer on the drain.

The washer will help to create a watertight seal between the drain and the trap. 2.

Screw the slip nut onto the drain.

The slip nut will hold the trap in place. 3.

Tighten the slip nut using pliers.

Be careful not to overtighten the slip nut, as this could damage the trap. 4.

Insert the trap into the drain.

The trap should fit snugly into the drain. 5.

Tighten the slip nut on the trap.

Again, be careful not to overtighten the slip nut. ### Tips *

Use a new washer each time you connect the sink drain to the trap.

If the trap is not fitting snugly into the drain, you can use a small amount of plumber's putty to help create a seal.

If you are having trouble tightening the slip nut, you can use a pair of pliers to help you.

### Troubleshooting *

If water is leaking from the connection between the sink drain and the trap, the washer may not be seated properly. Remove the trap and replace the washer.

If the trap is not draining properly, the drain may be clogged. Remove the trap and clean out the drain.

If you are having any other problems connecting the sink drain to the trap, you should consult a plumber.