Cut Hole In Stainless Steel Sink

Cutting a hole in a stainless steel sink is a relatively simple task that can be completed with a few basic tools. However, it is important to follow the steps carefully to avoid damaging the sink. The following instructions will guide you through the process of cutting a hole in a stainless steel sink.

Tools and Materials

Drill with a metal cutting bit
Hole saw with a metal cutting blade
Center punch
Hammer
Clamps
Safety glasses
Measuring tape
Pencil

Step-by-Step Instructions

Determine the location of the hole. Mark the center of the hole with a pencil.
Clamp the sink to a stable surface. This will help to prevent the sink from moving while you are drilling.
Put on safety glasses.
Use the center punch to make a small indentation at the center of the hole.
Attach the hole saw to the drill. Select a hole saw that is the same size as the hole you want to cut.
Start drilling slowly. Apply gentle pressure and allow the drill to do the work.
Once the hole is started, you can increase the speed of the drill.
Continue drilling until the hole is cut.
Remove the hole saw from the drill and clean the edges of the hole with a file or sandpaper.

Tips

Use a sharp metal cutting bit and hole saw. Dull tools will make the job more difficult and could damage the sink.
Drill slowly and apply gentle pressure. Forcing the drill could cause the bit to break or the sink to warp.
Use a clamp to secure the sink to a stable surface. This will help to prevent the sink from moving while you are drilling.
Wear safety glasses to protect your eyes from flying debris.
Clean the edges of the hole with a file or sandpaper to remove any sharp edges.