Install A Faucet On Bathroom Sink

Replacing a bathroom faucet is a relatively simple plumbing project that can be completed in an hour or two. With a few basic tools and a little bit of know-how, you can save yourself the cost of hiring a plumber.

Here are the steps on how to install a faucet on a bathroom sink:

1. Gather your tools and materials

You will need the following tools and materials to install a bathroom faucet:

Adjustable wrench
Pliers
Screwdriver
Plumber's putty
Faucet
Sink drain

2. Turn off the water supply

Before you begin working on the faucet, you need to turn off the water supply to the sink. There are usually two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to turn off the water.

3. Disconnect the old faucet

Once the water supply is turned off, you can disconnect the old faucet. First, use the adjustable wrench to loosen the nuts that hold the faucet in place. Once the nuts are loose, you can pull the faucet up and off the sink.

4. Clean the sink

Before you install the new faucet, you should clean the sink. Use a mild cleanser and a sponge to clean the sink basin and the area around the faucet holes.

5. Apply plumber's putty

Plumber's putty is a sticky substance that helps to seal the faucet to the sink. Roll out a small piece of plumber's putty and form it into a doughnut shape. Place the plumber's putty around the base of the faucet, where it will meet the sink.

6. Install the new faucet

Place the new faucet in the sink holes and push down until it is seated. Tighten the nuts that hold the faucet in place, but do not overtighten. Once the faucet is secure, turn on the water supply and check for leaks.

7. Connect the drain

The last step is to connect the drain to the sink. The drain is usually attached to the sink with a nut. Tighten the nut until the drain is secure, but do not overtighten.

Once the drain is connected, you are finished installing the new faucet. Congratulations!