Aquasana Under Sink Water Filter Replacement

Replacing the filter in your Aquasana under sink water filter is a quick and easy process that can be completed in just a few minutes. By following these simple steps, you can ensure that your filter is working properly and providing you with clean, healthy water.

Materials You'll Need:

New Aquasana under sink water filter
Wrench
Bucket or bowl

Step-by-Step Instructions:

Turn off the water supply to the filter.

This is usually done by closing the valve located under the sink.

Open the faucet to release any remaining water pressure in the line.

This will help prevent water from leaking when you remove the filter.

Use the wrench to loosen the filter housing.

The filter housing is the large, cylindrical-shaped component that contains the filter.

Remove the old filter from the housing.

Be careful not to spill any water.

Insert the new filter into the housing.

Make sure that the filter is properly seated in the housing.

Tighten the filter housing.

Use the wrench to tighten the housing until it is snug.

Turn on the water supply to the filter.

Check for any leaks.

Run the water through the filter for a few minutes to flush out any air bubbles.

This will help ensure that the filter is working properly.

Tips:

It is important to replace your Aquasana under sink water filter every six months to ensure that it is working properly and providing you with clean, healthy water.
If you notice a decrease in water pressure or a change in the taste or smell of your water, it may be time to replace the filter.
For more information on replacing your Aquasana under sink water filter, please refer to the user manual.