Bathroom Sink Pop Up Assembly

A bathroom sink pop up assembly is a device that controls the flow of water in and out of a bathroom sink. It is typically made of metal and consists of a drain stopper that is connected to a lift rod. When the lift rod is raised, the drain stopper opens, allowing water to flow out of the sink. When the lift rod is lowered, the drain stopper closes, blocking the flow of water.

Pop up assemblies are available in a variety of styles and finishes to match any bathroom décor. They are also relatively easy to install and can be replaced in a matter of minutes.

Types of Pop Up Assemblies

There are two main types of pop up assemblies: compression-type and lift-and-turn. Compression-type assemblies are the most common type and they use a rubber washer to create a seal between the drain stopper and the drain hole. Lift-and-turn assemblies use a ball-and-socket joint to create a seal. They are less common than compression-type assemblies, but they are generally more durable.

Pop up assemblies can also be classified by the type of finish they have. The most common finishes are chrome, brushed nickel, and oil-rubbed bronze. However, there are also a variety of other finishes available, such as gold, brass, and copper.

How to Choose a Pop Up Assembly

When choosing a pop up assembly, it is important to consider the following factors:

The type of sink you have
The finish you want
The size of the drain hole
The ease of installation

Once you have considered these factors, you can narrow down your choices and select the pop up assembly that is right for your needs.

How to Install a Pop Up Assembly

Installing a pop up assembly is a relatively easy process that can be completed in a matter of minutes. Here are the steps on how to install a pop up assembly:

1. Remove the old pop up assembly. To do this, simply unscrew the nut that holds the assembly in place. 2. Clean the drain hole. Use a cloth or brush to remove any dirt or debris from the drain hole. 3. Insert the new pop up assembly. Make sure that the rubber washer is in place and that the assembly is seated properly in the drain hole. 4. Tighten the nut. Use a wrench to tighten the nut that holds the assembly in place. Be sure not to overtighten the nut. 5. Test the pop up assembly. Open and close the drain stopper to make sure that it is working properly.