Changing Faucet On Pedestal Sink

Replacing a faucet on a pedestal sink is a relatively simple plumbing project that can be completed in a few hours. By following these step-by-step instructions, you can easily update the look of your bathroom and save money on the cost of hiring a plumber.

Materials Needed:

New faucet
Adjustable wrench
Basin wrench
Plumber's putty
Teflon tape
Bucket
Flashlight (optional)

Step-by-Step Instructions:

Turn off the water supply: Before starting any work, turn off the water supply to the sink. This is typically done by turning the handle on the shut-off valves located under the sink. If there are no shut-off valves, you will need to turn off the main water supply to the house.

Disconnect the old faucet: Once the water supply is turned off, disconnect the water lines from the old faucet. To do this, use an adjustable wrench to loosen the nuts that connect the lines to the faucet. Be careful not to overtighten the nuts, as this can damage the lines.

Remove the old faucet: Once the water lines are disconnected, you can remove the old faucet. To do this, reach under the sink and loosen the nuts that hold the faucet in place. Be careful not to drop the faucet into the sink, as this could damage the porcelain.

Prepare the new faucet: Before installing the new faucet, apply a thin layer of plumber's putty to the base of the faucet. This will help to create a watertight seal between the faucet and the sink.

Install the new faucet: Insert the new faucet into the hole in the sink and tighten the nuts that hold it in place. Be sure to tighten the nuts evenly to prevent the faucet from leaking.

Connect the water lines: Connect the water lines to the new faucet. To do this, use an adjustable wrench to tighten the nuts that connect the lines to the faucet. Be sure to wrap the threads of the nuts with Teflon tape to prevent leaks.

Turn on the water supply: Once the water lines are connected, turn on the water supply and check for leaks. If there are any leaks, tighten the nuts on the water lines until the leaks stop.

Test the faucet: Turn on the faucet and let it run for a few minutes to make sure that it is working properly. Check for any leaks around the base of the faucet or the water lines.

Finish up: Once the faucet is working properly, you can finish up by cleaning up any debris and putting away your tools. Enjoy your new faucet!