Glacier Bay Sink Faucet Parts

Glacier Bay faucets are known for their durability and style. However, even the best faucets can experience wear and tear over time. If your Glacier Bay faucet is leaking or not functioning properly, you may need to replace some of its parts. Here is a guide to help you identify and replace the most common Glacier Bay sink faucet parts:

Cartridge

The cartridge is the heart of the faucet. It controls the flow of water and the temperature. If your faucet is leaking or not functioning properly, the cartridge may need to be replaced. To replace the cartridge, you will need to:

Turn off the water supply to the faucet.
Remove the handle from the faucet.
Unscrew the cartridge retainer nut.
Pull the cartridge out of the faucet body.
Insert the new cartridge into the faucet body.
Tighten the cartridge retainer nut.
Reinstall the handle.
Turn on the water supply to the faucet and check for leaks.

Aerator

The aerator is located at the end of the faucet spout. It helps to create a more even stream of water and reduce splashing. If your aerator is clogged or damaged, it can cause the faucet to leak or spray water. To replace the aerator, you will need to:

Turn off the water supply to the faucet.
Use a wrench to unscrew the aerator from the faucet spout.
Clean or replace the aerator.
Screw the aerator back onto the faucet spout.
Turn on the water supply to the faucet and check for leaks.

O-Rings

O-rings are small rubber washers that create a watertight seal between the different parts of the faucet. Over time, O-rings can become worn or damaged, causing the faucet to leak. To replace an O-ring, you will need to:

Turn off the water supply to the faucet.
Disassemble the faucet.
Remove the old O-ring.
Lubricate the new O-ring with silicone grease.
Install the new O-ring.
Reassemble the faucet.
Turn on the water supply to the faucet and check for leaks.

Washers

Washers are thin, flat discs that create a watertight seal between the faucet handle and the faucet body. Over time, washers can become worn or damaged, causing the faucet to leak. To replace a washer, you will need to:

Turn off the water supply to the faucet.
Remove the handle from the faucet.
Remove the old washer.
Lubricate the new washer with silicone grease.
Install the new washer.
Reinstall the handle.
Turn on the water supply to the faucet and check for leaks.

Springs

Springs help to keep the faucet handle in place and to create a watertight seal. Over time, springs can become weak or damaged, causing the faucet to leak. To replace a spring, you will need to:

Turn off the water supply to the faucet.
Remove the handle from the faucet.
Remove the old spring.
Install the new spring.
Reinstall the handle.
Turn on the water supply to the faucet and check for leaks.

Retaining Nuts

Retaining nuts hold the different parts of the faucet together. Over time, retaining nuts can become loose or damaged, causing the faucet to leak. To replace a retaining nut, you will need to:

Turn off the water supply to the faucet.
Use a wrench to loosen the retaining nut.
Remove the old retaining nut.
Apply a small amount of sealant to the new retaining nut.
Install the new retaining nut.
Tighten the retaining nut.
Turn on the water supply to the faucet and check for leaks.

Diverter

The diverter is a small lever or button that controls the flow of water between the faucet spout and the side spray. If your diverter is not working properly, you may need to replace it. To replace the diverter, you will need to: