How Do I Replace A Bathroom Sink Drain

If your bathroom sink drain is clogged, slow, or leaking, you may need to replace it. Replacing a bathroom sink drain is a relatively easy task that can be completed in about an hour. Here are the steps on how to replace a bathroom sink drain:

1. Gather your materials. You will need a new bathroom sink drain, a wrench, a screwdriver, and a bucket.

2. Turn off the water supply to the sink. There are usually two water supply valves under the sink, one for hot water and one for cold water. Turn both valves clockwise to turn off the water supply.

3. Disconnect the old drain. Use the wrench to loosen the nuts that hold the old drain in place. Once the nuts are loose, you can pull the old drain out of the sink.

4. Clean the drain hole. Use a brush or a rag to clean any debris that may have accumulated in the drain hole.

5. Install the new drain. Place the new drain in the drain hole and hand-tighten the nuts. Use the wrench to further tighten the nuts, but do not overtighten them.

6. Reconnect the water supply. Turn the water supply valves counterclockwise to turn on the water supply. Check for any leaks around the new drain.

7. Test the drain. Run water into the sink to test the new drain. Make sure that the water drains properly and that there are no leaks.

Replacing a bathroom sink drain is a relatively easy task that can be completed in about an hour. By following these steps, you can save yourself the cost of calling a plumber.