How To Clean Sink Drain Trap

A clogged sink drain is a common household problem that can be easily fixed with a few simple steps. The drain trap, which is located under the sink, is often the culprit of a clogged drain.

The drain trap is a U-shaped pipe that holds water to create a seal that prevents sewer gases from entering the home. Over time, hair, soap scum, and other debris can build up in the drain trap, causing it to clog.

To clean the sink drain trap, you will need the following:

Bucket
Wrench
Plunger
Baking soda
Vinegar

Step 1: Place a bucket under the drain trap.

This will catch any water or debris that spills out when you remove the drain trap.

Step 2: Loosen the nuts on the drain trap.

There will be two nuts on the drain trap, one on each side. Use a wrench to loosen the nuts, but do not remove them completely.

Step 3: Remove the drain trap.

Once the nuts are loosened, you can remove the drain trap by pulling it straight down. Be careful not to spill any water or debris.

Step 4: Clean the drain trap.

Use a brush or your fingers to remove any hair, soap scum, or other debris from the drain trap. You can also use a baking soda and vinegar solution to clean the drain trap. To do this, pour 1/2 cup of baking soda down the drain, followed by 1/2 cup of vinegar. Let the solution sit for 15 minutes, then flush the drain with hot water.

Step 5: Reinstall the drain trap.

Once the drain trap is clean, reinstall it by reversing the steps you took to remove it. Tighten the nuts on the drain trap, but do not overtighten them.

Step 6: Test the drain.

Run water down the drain to test it. If the drain is still clogged, you may need to repeat the cleaning process.

Cleaning the sink drain trap is a simple task that can be done in a few minutes. By following these steps, you can keep your sink drain flowing freely.