How To Fix The Stopper In A Bathroom Sink

A bathroom sink stopper is a small device that plugs the drain hole and prevents water from flowing out. It is usually made of rubber or plastic and is attached to a metal rod that runs through the drain. When you lift the rod, the stopper pops up and allows water to flow out. When you lower the rod, the stopper drops down and plugs the hole. Over time, the stopper can become worn or damaged, and it may not work properly. If the stopper in your bathroom sink is not working properly, you can try to fix it yourself by following these steps:

Remove the stopper. To remove the stopper, lift the rod and pull the stopper out of the drain hole. If the stopper is stuck, you may need to use a pair of pliers to remove it.
Inspect the stopper. Once you have removed the stopper, inspect it for any damage. If the stopper is cracked or broken, you will need to replace it. If the stopper is not damaged, you can try to clean it.
Clean the stopper. To clean the stopper, use a mild soap and water solution. Apply the solution to the stopper and scrub it with a soft brush. Rinse the stopper thoroughly with clean water and dry it with a clean cloth.
Reinstall the stopper. To reinstall the stopper, insert it into the drain hole and push it down until it is seated. Lower the rod to hold the stopper in place.

If you have tried these steps and the stopper still does not work properly, you may need to replace it. To replace the stopper, follow these steps:

Purchase a new stopper. You can purchase a new stopper at a hardware store or home improvement store. Make sure to choose a stopper that is the correct size for your drain hole.
Remove the old stopper. To remove the old stopper, lift the rod and pull the stopper out of the drain hole. If the stopper is stuck, you may need to use a pair of pliers to remove it.
Install the new stopper. To install the new stopper, insert it into the drain hole and push it down until it is seated. Lower the rod to hold the stopper in place.

Once you have installed the new stopper, test it to make sure that it is working properly. Lift the rod and the stopper should pop up. Lower the rod and the stopper should drop down and plug the hole.

Fixing a bathroom sink stopper is a relatively simple task that can be completed in a few minutes. By following these steps, you can save yourself the cost of calling a plumber.