How To Install A Bathroom Sink Faucet

Installing a bathroom sink faucet is a relatively simple plumbing project that can be completed in a few hours. With the right tools and a little bit of know-how, you can save yourself a lot of money by doing it yourself. Here are the steps on how to install a bathroom sink faucet:

1. Gather your tools and materials

You will need the following tools and materials to install a bathroom sink faucet:

Adjustable wrench
Basin wrench
Pliers
Screwdriver
Plumber's putty
Teflon tape
New faucet
Shut-off valves (if necessary)

2. Turn off the water supply

The first step is to turn off the water supply to the sink. There should be two shut-off valves located under the sink. Turn both valves clockwise to turn off the water.

3. Remove the old faucet

Once the water supply is turned off, you can remove the old faucet. Start by disconnecting the water supply lines from the faucet. Use an adjustable wrench to loosen the nuts that hold the water supply lines in place. Once the water supply lines are disconnected, you can remove the faucet from the sink. To do this, use a basin wrench to loosen the nuts that hold the faucet in place. Once the nuts are loose, you can lift the faucet out of the sink.

4. Clean the sink surface

Once the old faucet is removed, you can clean the surface of the sink. Use a damp cloth to wipe away any dirt or debris. You can also use a mild cleaner to clean the surface of the sink.

5. Apply plumber's putty

Once the sink surface is clean, you can apply plumber's putty to the base of the new faucet. Plumber's putty is a type of sealant that helps to create a watertight seal between the faucet and the sink. To apply plumber's putty, roll it into a rope and then place it around the base of the faucet. Make sure to press the plumber's putty into place so that it creates a seal.

6. Install the new faucet

Once the plumber's putty is in place, you can install the new faucet. To do this, insert the faucet into the hole in the sink. Make sure that the faucet is properly aligned and that the plumber's putty is creating a seal. Once the faucet is in place, tighten the nuts that hold the faucet in place. You can use an adjustable wrench to tighten the nuts.

7. Connect the water supply lines

Once the faucet is installed, you can connect the water supply lines. To do this, attach the water supply lines to the faucet. Make sure that the water supply lines are properly tightened. You can use an adjustable wrench to tighten the water supply lines.

8. Turn on the water supply

Once the water supply lines are connected, you can turn on the water supply. Open the shut-off valves under the sink to turn on the water. Check for leaks around the faucet. If there are any leaks, tighten the nuts that hold the faucet in place.