How To Put In A Sink - Sink Remodels

How to Install a Sink

Installing a sink is a relatively straightforward project that can be completed in a few hours. By following these steps, you can ensure that your new sink is installed correctly and will last for years to come.

Materials You'll Need

New sink
Sink strainer
Plumber's putty
Silicone caulk
Wrench
Screwdriver
Level

Step 1: Remove the Old Sink

Start by turning off the water supply to the sink. Then, disconnect the water lines from the faucet. Once the water lines are disconnected, you can remove the old sink by unscrewing the mounting nuts that hold it in place.

Step 2: Clean the Sink Base

Once the old sink is removed, take some time to clean the sink base. Remove any old caulk or debris that may be present. This will help to ensure that the new sink is installed properly.

Step 3: Apply Plumber's Putty

Apply a bead of plumber's putty around the drain hole in the sink. The plumber's putty will help to seal the drain and prevent leaks.

Step 4: Install the Sink Strainer

Place the sink strainer over the drain hole and tighten it in place. The sink strainer will help to catch food and debris from going down the drain.

Step 5: Position the Sink

Position the sink in the sink base. Make sure that the sink is level and that it is centered in the opening. Once the sink is in place, tighten the mounting nuts to hold it securely.

Step 6: Connect the Water Lines

Reconnect the water lines to the faucet. Make sure that the water lines are tightened securely.

Step 7: Apply Silicone Caulk

Apply a bead of silicone caulk around the edge of the sink where it meets the countertop. The silicone caulk will help to seal the sink and prevent leaks.