How To Remove Faucet From Sink

Removing a faucet from a sink is a relatively simple task that can be completed in a few minutes with the right tools. By following these steps, you can safely and easily remove your faucet and replace it with a new one.

Materials You'll Need:

Adjustable wrench
Basin wrench
Phillips head screwdriver
Bucket
Rags

Step-by-Step Instructions:

1. Turn off the water supply: Before you begin, turn off the water supply to the sink. This will prevent water from spraying out when you remove the faucet.

2. Disconnect the water supply lines: Use an adjustable wrench to disconnect the water supply lines from the faucet. Place a bucket under the lines to catch any water that may leak out.

3. Remove the mounting nuts: Use a basin wrench to loosen the mounting nuts that hold the faucet in place. These nuts are typically located underneath the sink.

4. Pull out the faucet: Once the mounting nuts are loose, you can pull the faucet up and out of the sink. Be careful not to damage the sink or the faucet.

5. Clean the sink: Use a damp rag to clean the sink surface where the faucet was mounted. Remove any old sealant or debris.

6. Install the new faucet: Insert the new faucet into the sink hole. Tighten the mounting nuts using a basin wrench.

7. Connect the water supply lines: Connect the water supply lines to the new faucet. Use an adjustable wrench to tighten the connections.

8. Turn on the water supply: Turn on the water supply to the sink. Check for any leaks around the faucet. If there are any leaks, tighten the connections until the leaks stop.

Tips:

If you are replacing a faucet with a different type of faucet, you may need to purchase an adapter. Adapters are available at most hardware stores.
If you are having difficulty removing the mounting nuts, you can try using a penetrating oil. Apply the oil to the nuts and let it sit for a few minutes before trying to loosen them.
Be careful not to overtighten the mounting nuts. Overtightening can damage the sink or the faucet.