How To Replace A Bathroom Sink Stopper

A bathroom sink stopper is a small but important part of your sink. It helps to keep water in the sink when you need it and prevents it from draining out when you don't. Over time, stoppers can become worn out or damaged, and they may need to be replaced.

Replacing a bathroom sink stopper is a relatively easy task that can be completed in a few minutes. Here are the steps on how to do it:

Materials You'll Need:

New bathroom sink stopper
Adjustable wrench or pliers
Bucket or bowl
Putty knife or flat-head screwdriver

Step-by-Step Instructions:

1. Turn off the water supply to the sink. There are usually two valves under the sink, one for hot water and one for cold water. Turn both valves clockwise to turn off the water.

2. Open the faucet to release any remaining water in the lines. This will help to prevent water from leaking out when you remove the stopper.

3. Place a bucket or bowl under the drain to catch any water that may leak out.

4. Use an adjustable wrench or pliers to loosen the nut that holds the stopper in place. The nut is usually located on the underside of the sink, directly below the stopper.

5. Once the nut is loose, you can remove the stopper by pulling it straight up. If the stopper is stuck, you can use a putty knife or flat-head screwdriver to gently pry it loose.

6. Clean the area where the stopper was located. Remove any old sealant or debris that may have accumulated.

7. Apply a bead of sealant around the base of the new stopper. Be sure to apply the sealant evenly all the way around.

8. Insert the new stopper into the drain hole. Press down on the stopper to make sure it is seated properly.

9. Tighten the nut that holds the stopper in place. Be sure to tighten the nut securely, but do not overtighten it.

10. Turn on the water supply to the sink and check for leaks. If there are any leaks, tighten the nut further.

Replacing a bathroom sink stopper is a simple task that can be completed in a few minutes. By following these steps, you can easily replace your old stopper and keep your sink functioning properly.