How To Replace A Drop In Kitchen Sink

Replacing a drop-in kitchen sink is a relatively simple plumbing project that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber and have a new sink installed in no time.

Tools and Materials You Will Need:

New drop-in kitchen sink

Putty knife

Caulk gun

Caulk

Plumber's putty

Wrench

Pliers

Bucket

Screwdriver

Step-by-Step Instructions:

1. Remove the old sink.

Start by turning off the water supply to the sink. Then, use a putty knife to carefully remove the old caulk around the edge of the sink. Once the caulk is removed, you can use a wrench to loosen the nuts that hold the sink in place. Finally, lift the sink out of the countertop and place it in a safe place.

2. Clean the countertop.

Once the old sink is removed, it is important to clean the countertop thoroughly. This will help to ensure that the new sink will fit properly and that there will be no leaks. Use a degreaser and a sponge to clean the countertop, and then rinse it with water and dry it with a clean cloth.

3. Apply a bead of caulk.

Before installing the new sink, it is important to apply a bead of caulk around the edge of the countertop. This will help to seal the sink and prevent leaks. Use a caulk gun to apply a thin bead of caulk around the edge of the countertop, and then smooth it out with your finger.

4. Set the sink in place.

Once the caulk is applied, you can set the new sink in place. Carefully lift the sink and position it over the countertop. Make sure that the sink is centered and that the front edge is flush with the edge of the countertop. Once the sink is in place, press down on it firmly to seat it in the caulk.

5. Tighten the nuts.

Once the sink is in place, you can tighten the nuts that hold it in place. Use a wrench to tighten the nuts until they are snug, but do not overtighten them. Once the nuts are tightened, the sink is secure.

6. Connect the plumbing.

Next, you need to connect the plumbing to the sink. Start by attaching the water supply lines to the faucet. Then, connect the drain line to the sink. Make sure that all of the connections are tight, but do not overtighten them.

7. Turn on the water supply.

Once the plumbing is connected, you can turn on the water supply to the sink. Check for leaks around the sink and the plumbing connections. If you find any leaks, tighten the connections until they are leak-free.