How To Replace A Kitchen Sink Faucet

Replacing a kitchen sink faucet is a relatively simple plumbing task that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber.

Tools and materials you will need:

New kitchen sink faucet
Adjustable wrench
Basin wrench
Plumber's putty
Teflon tape
Bucket
Flashlight

Step 1: Turn off the water supply.

There are typically two shutoff valves under the sink. Turn both valves clockwise until they are completely closed. If your sink does not have shutoff valves, you will need to turn off the main water supply to your home.

Step 2: Disconnect the water lines.

Use an adjustable wrench to loosen the nuts that connect the water lines to the old faucet. Be careful not to damage the water lines.

Step 3: Remove the old faucet.

Use a basin wrench to loosen the nuts that hold the old faucet in place. Once the nuts are loose, you can pull the old faucet out of the sink.

Step 4: Clean the sink surface.

Use a damp cloth to clean the surface of the sink where the new faucet will be installed. This will help to ensure that the new faucet will seal properly.

Step 5: Apply plumber's putty.

Roll a small piece of plumber's putty into a rope and place it around the base of the new faucet. This will help to seal the faucet and prevent leaks.

Step 6: Install the new faucet.

Insert the new faucet into the sinkhole and tighten the nuts until they are snug. Be careful not to overtighten the nuts, as this could damage the faucet.

Step 7: Connect the water lines.

Use Teflon tape to wrap the threads of the water lines. This will help to prevent leaks. Then, connect the water lines to the new faucet and tighten the nuts until they are snug.

Step 8: Turn on the water supply.

Slowly turn on the shutoff valves under the sink. Check for leaks around the base of the faucet and the water lines. If you find any leaks, tighten the nuts until the leaks stop.

Step 9: Test the faucet.

Turn on the faucet and check that the water flows smoothly and that the temperature is correct. If everything is working properly, you are finished.