Installing A Kitchen Sink Faucet

Installing a kitchen sink faucet is a relatively simple task that can be completed in a few hours. By following these step-by-step instructions, you can easily replace your old faucet with a new one.

Tools and Materials You'll Need:

New kitchen sink faucet
Adjustable wrench
Phillips screwdriver
Plumber's putty
Teflon tape
Bucket

Step-by-Step Instructions:

1. Turn off the water supply: Under the sink, locate the two water supply valves (usually hot and cold). Turn the valves clockwise to shut off the water supply.

2. Disconnect the old faucet: Using an adjustable wrench, loosen the nuts that hold the old faucet in place. Detach the water supply lines and lift the faucet out of the sink.

3. Clean the sink surface: Remove any old plumber's putty or debris from the sink surface where the new faucet will be installed.

4. Apply plumber's putty: Roll out a small piece of plumber's putty and form a ring around the base of the new faucet. This will help create a watertight seal.

5. Install the faucet: Place the new faucet into the sink hole and tighten the nuts by hand. Use an adjustable wrench to further tighten the nuts, but avoid overtightening.

6. Attach the water supply lines: Apply Teflon tape to the threads of the water supply lines. Connect the lines to the corresponding hot and cold water valves under the sink. Tighten the connections using an adjustable wrench.

7. Turn on the water supply: Open the water supply valves under the sink. Check for any leaks around the faucet or water supply lines. Tighten any loose connections if necessary.

8. Install the faucet handle: Insert the faucet handle into the stem and secure it with the provided screw or nut.

9. Test the faucet: Run water through the faucet to ensure it is working properly. Check for leaks around the handle or base of the faucet.

Congratulations! You have successfully installed your new kitchen sink faucet.