Pur Water Filter Sink Replacement

PUR Water Filter Sink Replacement

Replacing a PUR water filter sink is a straightforward task that can be completed in a few simple steps. By following these instructions, you can ensure that your water filter is working properly and providing you with clean, fresh water.

Materials Needed

Before you begin, gather the following materials:

New PUR water filter sink

Wrench or adjustable pliers

Clean cloth or towel

Step-by-Step Instructions

1. Turn off the water supply: Start by turning off the water supply to your sink. This is usually done by turning the valve under the sink clockwise.

2. Remove the old sink: Once the water supply is turned off, disconnect the water lines from the old sink. Then, use a wrench or adjustable pliers to loosen the nuts that hold the sink in place. Carefully lift the sink off the countertop.

3. Clean the countertop: Use a clean cloth or towel to wipe down the countertop where the old sink was located. This will remove any dirt or debris that may have accumulated.

4. Install the new sink: Place the new sink on the countertop and align it with the holes for the water lines. Tighten the nuts that hold the sink in place until they are snug.

5. Connect the water lines: Connect the water lines to the new sink. Make sure that the lines are securely tightened to prevent leaks.

6. Turn on the water supply: Slowly turn on the water supply under the sink. Check for any leaks at the connections. If you find any leaks, tighten the nuts until the leaks stop.

7. Flush the system: Run water through the new sink for several minutes to flush out any air or impurities. This will also help to activate the water filter.

Your PUR water filter sink replacement is now complete. Enjoy clean, fresh water from your faucet!