Rv Kitchen Sink Faucet Replacement

Replacing a kitchen sink faucet in an RV is a relatively simple task that can be completed in a few hours. By following these steps, you can save yourself the cost of hiring a plumber.

Step 1: Gather your tools and materials.

You will need the following tools and materials to replace your RV kitchen sink faucet:

New kitchen sink faucet
Wrench
Screwdriver
Pliers
Plumber's putty
Teflon tape

Step 2: Turn off the water supply.

Before you begin working on the faucet, it is important to turn off the water supply to your RV. You can do this by closing the water valves located under the sink.

Step 3: Disconnect the old faucet.

Once the water supply is turned off, you can disconnect the old faucet. To do this, use a wrench to loosen the nuts that are holding the faucet in place. Once the nuts are loose, you can pull the faucet out of the sink.

Step 4: Clean the sink and faucet base.

Before you install the new faucet, it is important to clean the sink and faucet base. This will help to ensure that the new faucet is properly sealed and will not leak.

Step 5: Apply plumber's putty to the new faucet.

Once the sink and faucet base are clean, you can apply plumber's putty to the base of the new faucet. Plumber's putty is a sealant that will help to prevent leaks. To apply plumber's putty, simply roll it into a snake-like shape and wrap it around the base of the faucet.

Step 6: Install the new faucet.

Once the plumber's putty is in place, you can install the new faucet. To do this, simply insert the faucet into the sink and tighten the nuts that are holding it in place. Be sure to tighten the nuts securely, but do not overtighten them.

Step 7: Connect the water supply.

Once the new faucet is installed, you can connect the water supply. To do this, simply attach the water lines to the faucet and tighten the nuts that are holding them in place. Be sure to tighten the nuts securely, but do not overtighten them.

Step 8: Test the new faucet.

Once the water supply is connected, you can test the new faucet. To do this, simply turn on the water and check for leaks. If there are any leaks, you can tighten the nuts that are holding the faucet in place or apply more plumber's putty.